Non-Isolated Digital Input/Output (Di/O) Module - Emerson ControlWave EFM Instruction Manual

Electronic flow meter
Table of Contents

Advertisement

3.3 Non-isolated Digital Input/Output (DI/O) Module

Detailed Technical
Specifications
Setting Jumpers DI/O modules provide 12 individually field configurable DIs and 4
Table 3-2. Jumper Assignments: Non-isolated DI/O Module
Jumper
Purpose
W1-W12
Configures DI1 through DI12
(respectively)
W13
Enables LEDs
Revised Dec-2013
Non-isolated DI/O modules consist of a digital input/output PCB with
two 10-point terminal block assemblies for local termination. The DI/O
module also includes 14 configuration jumpers, an LED board with 16
status LEDs (one for each point), and a cover assembly. The DI/O
module connects with the backplane using a 36-pin gold-plated card-
edge connector.
Non-isolated DI/O modules contain field interface circuitry for up to 12
digital inputs and four digital outputs.
Table 3-1. Non-Isolated DI/DO Module General Characteristics
Type
Number
Supported
12
Digital
Inputs (DI)
4
Digital
Outputs
(DO)
For detailed technical specifications, please see our website
http://www.emersonprocess.com/remote.
non-configurable externally powered DOs.
Using configuration jumpers W1 through W12, you can set each DI
individually to provide either a 2 mA or 60 uA source current. Table 3-2
details jumper settings.
Description
Pins 1-2 installed = 2mA Source Current
Pins 2-3 installed = 60uA Source Current
Pins 1-2 installed = allows manual enabling of LEDs
I/O Modules
ControlWave EFM Instruction Manual
Characteristics
Each DI supports/ includes:
 Internally sourced DI operation for dry
contacts pulled internally to 3.3Vdc when
field input is open.
 Surge suppressor
 Signal conditioning
 Filter time of 15 ms
 Jumper to configure source current for either
2 mA or 60 uA
 Dedicated LED on module turns ON when
DI is ON.
Each DO supports/ includes:
 Open drain MOSFET provides 100mA at
30Vdc to an externally powered device.
 Surge suppressor
 Current sink to ground of DI/DO module
Dedicated LED on module turns ON when
DO is ON.
3-5

Advertisement

Table of Contents
loading

Table of Contents