WCP GreyT Elevator V3 User Manual page 8

GreyT Elevator V3 - User Guide
(Rev 1)
Hex Shaft Cut Guide
The "Pulley Shaft" and
the elevator made.
The "VersaPlanetary Connecting Shaft"
have be installed to ensure the shaft is not too long. This shaft can have up to a 1/4" gap
between it and the VersaPlanetary output shaft.
The "Sprocket Shaft"
Table of Contents
"Ratcheting Shaft"
should be measured and cut after the motors
length is dependent on the size of the elevator that is made.
wcproducts.com
lengths are universal regardless of the size of
Page 8