WCP GreyT Elevator V3 User Manual page 19

GreyT Elevator V3 - User Guide
(Rev 1)
Step 8
The bearings should be a slip or a light press fit into the Centered Bearing Plates. Install
the bearings into the plates before installing the plates onto the 1st stage.
Use two #10-32 x 2-1/2"L bolts to attach each pair of bearing plates to the 1st stage
horizontal tubes.
Note: All the holes in the bearing plates are tapped� On two plates the tapped holes
need to be drilled to clearance for #10-32 bolts�
Table of Contents Page 19
wcproducts.com