WCP GreyT Elevator V3 User Manual page 24

GreyT Elevator V3 - User Guide
(Rev 1)
Step 13
The bearings should be a slip or a light press fit into the Centered Bearing Plates. Install
the bearings into the plates before installing the plates onto the carriage.
Use two #10-32 x 2-1/2"L bolts to attach the pair of bearing plates to the carriage.
Note: All the holes in the bearing plates are tapped� On one plate the tapped holes need
to be drilled clearance for #10-32 bolts�
Table of Contents Page 24
wcproducts.com