WCP GreyT Elevator V3 User Manual page 10

GreyT Elevator V3 - User Guide
(Rev 1)
Step 1
Install all bearings as shown in the image below. The 6mm ID x 12mm OD radial bearing
will sit on the 1/4" shoulder on the bearing block, and the #8-32 x 3/8"L bolt will be used
to retain the bearing.
Note: Eight of the Clamping Elevator Blocks will be assembled without the 1/4" ID x
3/4" OD radial bearing or shoulder bolt�
Table of Contents Page 10
wcproducts.com