WCP GreyT Elevator V3 User Manual page 25

GreyT Elevator V3 - User Guide
(Rev 1)
Step 14
Install the Bearing Blocks as shown in the image below. The holes indicated in green
must be drilled clearance for #10-32. The Bearing Blocks use 1/2" hole spacing.
Repeat this step for both sides of the carriage.
Note: Make sure to install the bearing blocks with the 3/4" radial bearings on the front
of the carriage and the bearing blocks without the 3/4" radial bearings on the back�
Table of Contents Page 25
wcproducts.com