WCP GreyT Elevator V3 User Manual page 27

GreyT Elevator V3 - User Guide
(Rev 1)
Step 16
Bolt the 3/4" OD radial bearings into the bearing blocks on the backside of the carriage.
The bearing blocks where they must be installed are indicated in green in the image
below.
At this point, the elevator carriage should be able to move smoothly up/down, and a
small amount of wiggle left/right and front/back is to be expected. This ensures the
elevator will not bind.
Table of Contents Page 27
wcproducts.com