Advertisement
GreyT Elevator V3 - User Guide
(Rev 1)
Step 9
Bolt the chain spacer plate to the back of the 1st stage in the orientation shown in the
image below. The spacer plate will be installed using #8-32 x 2-1/4"L bolts.
Mirror this step for the other side of the 1st stage.
Note: It is recommended to install the chain spacer plate as low as possible on the
1st stage� The height from the bottom of the 1st stage is determined by the clamping
blocks installed in step 10�
Table of Contents
Page 20
wcproducts.com
Advertisement
