WCP GreyT Elevator V3 User Manual page 16

GreyT Elevator V3 - User Guide
(Rev 1)
Step 5
Press the 1/2" ThunderHex bearing into the Sprocket Mounting Plate. Repeat this step
for the other plate, and make sure that the bearings are on opposite sides of the plate.
The Sprocket Mounting Plate will align with the bottom of the Clamping Elevator Blocks,
and the front will align with the front of the Mast Tubes. Use a #21 drill bit to match drill
the holes into the Elevator Mast Tubes. Remove the plate and drill the holes in the tubes
clearance for #10-32 bolts. Install the plates using #10-32 x 1-1/4"L bolts.
Repeat this step for both Elevator Mast Tubes.
Note: The holes in the Sprocket Mounting Plate must be tapped to #10-32 before
installation�
Table of Contents Page 16
wcproducts.com