WCP GreyT Elevator V3 User Manual page 7

GreyT Elevator V3 - User Guide
(Rev 1)
Tubing Cut Guide (Continued)
The overall length for these tubes is for the elevator represented in the CAD model. This
can be changed to fit the requirements of any design.
Ensure that when cutting tubes, the distance from the last hole to the end of the tube
is the same as the image below. Usually this means that the tube length must be in
1/2" increments. This distance is required for the bearing blocks and tube plugs to fit
properly. If VersaFrame tubing is not used then tubes can be any length.
Note: It is recommended to cut the tubes longer than needed and then mill to the
correct length� Alternately, a chop saw may be used� The ends of the tubes should be
as flat and square as possible.
Table of Contents Page 7
wcproducts.com