Advertisement
GreyT Elevator V3 - User Guide
(Rev 1)
Step 25
Follow the diagram below for running the rope.
The beginning of the rope can be looped around the shaft with the hex wrench but the
end must be ran through the drilled hole. This ensures that only one end is being wound
up.
A few wraps of string are recommended before the string begins to get tight. Tension
string to desired level.
Note: String may need to be retensioned after the elevator has been powered� This is
due to the string stretching due to the knot fully tightening after having a load applied�
Table of Contents
Page 36
wcproducts.com
Advertisement
