WCP GreyT Elevator V3 User Manual page 37

GreyT Elevator V3 - User Guide
(Rev 1)
Step 26
Center the rope clamp blocks on the rope. Match drill the holes through the plates and
into the elevator mast cross tube. When looking from the front of the elevator, the clamp
block goes on the left most rope.
Install one block behind the rope and one in front of the rope. Use a minimum of four
#10-32 bolts to clamp the rope to the cross tube. Before tightening the blocks, ensure
that all stages of the elevator are at the bottom.
Note: Heavily chamfer the edge of the blocks that the rope passes through so as to not
damage the rope� Failure to do so will cause a rip in the rope� Be aggressive with the
chamfer�
Table of Contents Page 37
wcproducts.com