Table of Contents
Advertisement
• When removing or installing a component that is subject to ESD damage, always place it component-
side up on an antistatic surface, in an antistatic card rack, or in an antistatic bag (see
page
61). If you are returning a component, place it in an antistatic bag before packing it.
Figure 18: Placing a Component into an Antistatic Bag
CAUTION: ANSI/TIA/EIA-568 cables such as Category 5e and Category 6 can get
electrostatically charged. To dissipate this charge, always ground the cables to a suitable
and safe earth ground before connecting them to the system.
Attention Les câbles ANSI/TIA/EIA-568, par exemple Cat 5e et Cat 6, peuvent
emmagasiner des charges électrostatiques. Pour évacuer ces charges, reliez toujours les
câbles à une prise de terre adaptée avant de les raccorder au système.
Fire Safety Requirements
IN THIS SECTION
Fire Suppression | 62
61
Figure 18 on
Advertisement
Table of Contents
