Seaga JDL-2 COMBO Service And Parts Manual page 51

Motor Errors
Error Message
Motor [Number] Open
Motor [Number] Short
Motor [Number] Home Sns
Motor [Number] Jam
Motor [Number] Errors
Motor Under Voltage
Temperature Sensor Errors
Error Message
Refrig Sensor # Open
Refrig Sensor # Short
Refrig Health Safety
Vend Sensor Errors
Error Message
Optical Sensor Error
JDL V1.0 8 2022
Description
The motor indicated or harness to
that motor has an open electrical
connection.
The motor or harness has an elec-
trical short.
The motor home switch was not
detected while the motor was in
operation. This may also indicate a
motor jam condition.
A motor jam has been detected.
One or more motor errors have
been detected.
The detected motor voltage is not
high enough to run the selection
motors.
Description
A temperature sensor or harness is
considered to have an open elec-
trical connection. Where # is the
sensor number.
A temperature sensor or harness
is considered to have an electri-
cal short. Where # is the sensor
number.
The cabinet temperature and time
limit settings have been exceeded.
Description
Not Applicable
Possible Solutions
Check the motor and motor harness
for open connections. Test vend motor.
Replace if necessary.
Check motor and motor harness for
short. Replace if necessary.
Check motor type service mode setting,
motor, motor switch and then spiral for
blockage. Test vend selection motor if
necessary.
Check motor and spiral for blockage.
Test vend selection motor and review
information on motor open, short, home
switch and jam conditions.
Test vend selection motor for correct
operation. Replace motor. Replace VMC.
Possible Solutions
Check sensor and sensor harness for
open connections. Check for sensor
readings. Replace sensor if necessary.
Check sensor and sensor harness for
shorted connections. Replace if neces-
sary.
Check sensor readings and sensor
harness for shorted connections. Check
for sensor readings. Replace sensor if
necessary.
Possible Solutions
NA
51