Printing The Menu Map; Using The Menu Selection System; Printing Status Page - Kyocera FS-9120DN Operating Manual

2.2 Using the Menu Selection System

This section explains the procedure for using the menu selec-
tion system. The menu selection system is activated by the
MENU key while the printer is Ready.

2.2.1 Printing the Menu Map

The printer prints a full list of menu selections. Note that
menus indicated on the list may vary depending on which op-
tion units are installed on the printer.
1 Press the MENU key.
2 Press the or
Map appears.
Print
Menu Map
3 Press the ENTER key. A question mark (?) appears.
Print
Menu Map ?
4 Press the ENTER key again. The printer prints a
menu map.
Figure 3-2
key repeatedly until Print Menu
MENU MAP
Chapter 3 Using the Operator Panel

2.2.2 Printing Status Page

If you want to check the printer's current status, including
memory available and option settings, you can find the infor-
mation you need on the status page.
1 Press the MENU key.
2 Press the or
Status Page appears.
Print
Status Page
3 Press the ENTER key. A question mark (?) appears.
Print
Status Page
4 Press the ENTER key again. The printer prints a
status page.
NOTE
For a full description of the status, see the following sample
status page.
The following is a sample status page. The numbers below re-
fer to the contents explained on the next page.
STATUS PAGE
Hardware Information
2
Page Information
4
Network Status
6
Interfaces
KIR
Test pattern
Figure 3-3
When the Network Status is turned on, the Network Interface Sta-
tus Page will be printed after the Printer Status. (See
key repeatedly until Print
?
1
Firmware Version: Released:
Memory
3
Installed Options
5
Emulation
7
Error Log
8
Toner Gauge
9
100
0
0
A
ON
page 3-20 .)
3-11