Kyocera FS-9120DN Operating Manual page 37

Chapter 3 Using the Operator Panel
6 Press the ENTER key again. The printer prints a
Code Job list as shown below.
PERMANENT CODE JOB LIST
Figure 3-6
Retrieving Jobs from Virtual Mailbox (VMB)
To retrieve the jobs posted in the virtual mailbox, proceed as
follows.
1 Press the MENU key.
2 Press the or
pears.
e-MPS
3 Press the key.
4 Press the or
Data appears. The virtual mailbox number will also
appear.
>Print VMB Data
Tray001:
If you have named the virtual mailbox with an alias on
the printer driver, the alias (Richard, in this example)
will follow the number:
>Print VMB Data
Tray001:Richard
5 Press the ENTER key. A blinking question mark (?)
appears.
>Print VMB Data
Tray001?
6 Press the ENTER key. The document in the mailbox
is printed and automatically deleted from the mail-
box.
3-16
key repeatedly until e-MPS > ap-
>
key repeatedly until >Print VMB
Printing a List of VMB
A Virtual Mailbox list includes the jobs currently stored in
the mailboxes.
1 Press the MENU key.
2 Press the or
pears.
e-MPS
3 Press the key.
4 Press the or
VMB appears.
>List of VMB
5 Press the ENTER key. A question mark (?) appears.
>List of VMB ?
6 Press the ENTER key again. The printer prints a list of
jobs currently posted in the virtual mailboxes as shown
below.
VIRTUAL MAIL BOX LIST
Figure 3-7
Changing e-MPS Configuration
You can change the following parameters for e-MPS opera-
tion:
• Maximum number of Quick Copy/Proof-and-Hold jobs
• Maximum space assigned to temporary code jobs
• Maximum space assigned to permanent code jobs
• Maximum space assigned to virtual mailboxes
NOTE
The total amount of storage area specified must not exceed the
total size of the hard disk. Otherwise, you may only be able to
accommodate a smaller number of print jobs than specified.
key repeatedly until e-MPS > ap-
>
key repeatedly until >List of