Message Display; Operation Indicators; Interface Indicator - Kyocera FS-9120DN Operating Manual

Chapter 3 Using the Operator Panel

1.1 Operation Indicators

The following indicators light up during normal operation
and when the printer needs attention.
Indicator Description
Flashing: Indicates when an error occurs
that you can clear by yourself.
Lit: Indicates that the printer is on-line.
The printer prints received data.
Off: Indicates that the printer is off-line.
READY
Data can be received but will not be
printed. Also indicates when printing is
automatically stopped due to occurrence
of an error.
Flashing: Indicates data transfer is
taking place.
Lit: Indicates either that data is being
DATA
processed, or that data is being written to
the memory card.
Flashing: Indicates when the printer
needs maintenance attention or the
printer is warming up (Please wait).
Lit: Indicates when a problem or an error
ATTENTION
occurs that you can clear by yourself. (For
example, paper jam occurs.)
1Flashing: Indicates when no paper is
detected.
Fast-Flashing: Indicates that a paper
jam is occurring.
Lit: Indicates that the MP tray is
selected.
2Flashing: Indicates when the cassette
or paper is not detected, or when the
3 1
paper is loading.
Fast-Flashing:Indicates that a paper
2
jam is occurring.
Lit: Indicates that the cassette is
selected.
3Flashing: Indicates that there is paper
jam in the optional finisher.
Lit: Indicates that the document
finisher is being selected.
Table 3-1
3-2

1.2 Message Display

The message display gives information in the form of short
messages. The eight messages listed below are displayed dur-
ing normal warm-up and printing.
Other messages that may appear when the printer needs the
operator's attention are explained
Message Meaning
The printer is self-testing after power-
Self test
up.
The printer is warming up and is not
Please wait
ready. When the printer is switched on
for the first time after the toner
container is installed, (Adding toner)
also appears.
The printer is ready to print.
Ready
The
Processing
generating graphics, reading a memory
card/hard disk, or printing.
The printer is in Sleep mode. The
Sleeping
printer
whenever a key on the operator panel is
pressed, the cover is opened or closed,
or data is received. The printer then
warms up and goes online. The time
that the printer takes to enter Sleep
mode depends on the Sleep Timer
setting.
Cancelling data Jobs inside the printer are being
canceled. To cancel a job, see the table
on page 3-4
The printer is waiting for the end-of-job
Waiting
command before printing the last page.
Pressing the GO key allows you to
obtain the last page immediately.
The printer is printing the last page
FormFeed TimeOut
after a waiting period.
Table 3-2

1.3 Interface Indicator

The interface Indicator shows the interface that is currently
used. It uses the following abbreviations:
PAR Parallel interface
USB USB interface
Network interface
NET
Network interface card (option)
OPT
Serial (RS-232C) interface (option)
SER
No interface is active.
---
Each interface has a timeout time of 30 seconds during which
the other interface should wait to receive a print job. Even if
a print job has been completed on the interface, you should
wait for this period until the other interface begins printing
the job.
on page 4-4
.
printer is receiving
wakes from Sleep
.
data,
mode