Kyocera FS-9120DN Operating Manual page 34

Job Storage
Job storage stores print jobs either temporarily or perma-
nently, or in virtual mailboxes, as you click an appropriate ra-
dio button on the printer driver when printing from a
computer.
Virtual Mailbox
Virtual mailbox is part of Job Storage, which stores print jobs
on the hard disk without printing. It enables you to retrieve
jobs later from the operator panel.
Each mailbox may be used by an individual who desires to
share the printer in this mode. By default, each mailbox is
numbered from 'Tray 001,' 'Tray 002,' ... etc. To 'post' a job in
one of these mailboxes, you assign a numbered or named
mailbox on the printer driver when printing.
To retrieve the stored job for printing, see
from Virtual Mailbox (VMB) on page 3-16
NOTE
The virtual mailbox can be used in PCL 6 emulation only.
Using Quick Copy
This mode enables you to print the requested number of cop-
ies of a job, simultaneously storing the job on the hard disk.
When additional copies are required, you can reprint the re-
quired number of copies from the printer operator panel. To
print a job as a quick copy job, see
The default number of print jobs that can be stored on the hard
disk is 32. This value can be increased to up to 50 from the e-
MPS Configuration menu. For details, see
Configuration on page 3-16
the limit, the oldest job will be overwritten by the new one.
When the printer is turned off, all stored jobs will be deleted.
Printing Additional Copies using Quick Copy
To print additional copies of a job stored in the printer:
1 Press the MENU key.
2 Press the or
pears.
e-MPS
3 Press the key.
4 Press the or
appears followed by the user name (Harold, in this
example). The user name is assigned at printing us-
ing the printer driver.
>Quick Copy
Harold
Retrieving Jobs
.
Printer Driver Guide
Changing e-MPS
. When the number of jobs reaches
key repeatedly until e-MPS > ap-
>
key repeatedly until >Quick Copy
5 Press the ENTER key. A blinking question mark (?)
appears before the user name.
>Quick Copy
?Harold
6 Press the
name, Arlen, in this example.
>Quick Copy
?Arlen
7 Press the ENTER key. The job name entered in the
printer driver (Report, in this example) appear with
a blinking question mark (?) before the letters.
>Arlen
?Report
8 Press the
9 Press the ENTER key. The number of copies to be
printed can be set. To increase the copy count, press
the
.
>Report
Copies
10 Press the ENTER key to finalize the copy count. The
printer prints the specified number of copies for the job.
Deleting a Quick Copy Job
All quick copy jobs are automatically deleted when the print-
er is turned off. If you desire to explicitly delete a stored quick
copy job, proceed as follows:
1 Follow steps 1 through 8 in the above section to dis-
play the title of the job to be deleted.
2 When the title of the job to be deleted is displayed,
e.g. Report, below, press the ENTER key. The cursor
below the copy count starts to blink.
>Report
Copies
3 Press the
below the title.
>Report
Delete
4 Press the ENTER key. The stored quick copy job is de-
leted.
Chapter 3 Using the Operator Panel
or key to display the desired user
or key to scroll to the desired job title.
key; to decrease the copy count, press the
001
001
key repeatedly until Delete appears
_
key.
3-13