Kyocera FS-9120DN Operating Manual page 70

Message Language Selection
You can select the language of the messages on the message
display by following the procedure given below.
1 Press the MENU key.
2 Press the or
pears.
Others
3 Press the key.
4 Press the or
Language appears. The default message language is
English.
>MSG Language
English
5 To change the language, press the ENTER key. A
blinking question mark (?) appears.
>MSG Language
? English
6 Press the key. The display cycles through the
available selections in the following order (The
key cycles in the reverse order):
English
Francais
Deutsch
Italiano
Nederlands
Espanol
Portugues
7 Press the ENTER key.
8 Press the MENU key. The message display returns to
Ready.
Automatic Form Feed Timeout Setting
When the printer receives no data for a certain time, it times
out and releases the current interface: it prints whatever
data it has in its buffer and feeds out the page. You can ad-
just the time-out time as follows:
1 Press the MENU key.
key repeatedly until Others > ap-
>
key repeatedly until >MSG
Chapter 3 Using the Operator Panel
2 Press the or
pears.
Others
3 Press the key.
4 Press the or
Time Out appears. The default setting is 30 seconds.
>Form Feed
Time Out 030sec.
5 Press the ENTER key. A blinking cursor (_) appears.
>Form Feed
Time Out 030sec.
6 Press the or
ue of the figure where the cursor is blinking and set
the desired time. The time can be set between 0 and
495 seconds, in 5-second increments. (The printer
does not timeout with the value set to 0.) You can use
the and keys to move the cursor right and left.
7 Display the desired time and press the ENTER key.
8 Press the MENU key. The message display returns to
Ready.
Sleep Timer Setting
The printer has a sleep timer to conserve power when the
printer is not printing, processing, or receiving data. You can
adjust the timer value, the length of time the printer waits
before entering sleeping mode in the absence of data.
1 Press the MENU key.
2 Press the or
pears.
Others
3 Press the key.
key repeatedly until Others > ap-
>
key repeatedly until >Form Feed
key to increase or decrease the val-
key repeatedly until Others > ap-
>
3-49