Kyocera FS-9120DN Operating Manual page 108

5 The Properties sheet is displayed for the selected
COM port. Click on the Port Settings tab and set the
port properties.
Figure B-4
6 After setting the properties, click the OK button.
I I I I DOS
1 Enter the following commands:
C:\>MODE COM1:96,N,8,1,P
C:\>MODE LPT1:=COM1
2 To test the interface, enter the following:
CTRL P
C:\>DIR
CTRL P
The software settings made using the above procedures are
temporary. On most computers, permanent settings must be
made with DIP switches.
Appendix B Host Computer Interface
B-6