Setting Pre-Amplifier Selector Switch - Audio Technica AT-LPW50BT User Manual

Using the product with a wired connection
According to the settings for the pre-amplifier selector switch, connect the RCA audio cable to an input jack on the
connectable equipment you are using (amplifier, receiver, active speakers, sound card, etc.).

Setting pre-amplifier selector switch

This product has a built-in phono equalizer function. Even if you do not have a phono amplifier or any other
connectable equipment with a built-in phono amplifier, you can use this product by connecting it to active speakers.
Use the pre-amplifier selector switch to set the output as shown below.
When connecting the product to a Bluetooth device, set the pre-amplifier selector switch to LINE.
Device with phono input
Position of pre-amplifier selector
switch
PHONO
Device without phono input
Position of pre-amplifier selector
switch
LINE
PC sound card
Position of pre-amplifier selector
switch
LINE
[1] An audio adapter (sold separately) may be required to connect the RCA audio cable to the PC sound card's line input jack.
Connecting to the active speaker (with the built-in amplifier)
To connect this product directly to speakers, use active speakers.
Some active speakers can only be connected with a conversion cable.
Where to connect the RCA audio cable
Phono input jack and ground (earth) terminal of connectable equipment
Where to connect the RCA audio cable
AUX or line input jack of connectable equipment
Where to connect the RCA audio cable
[1]
Sound card's line input jack
24