Table of Contents
Advertisement
Preparation for use
Setting pre-amplifier selector switch
This product has a built-in phono equalizer function. You can use the
product, even if you do not have a phono amplifier or connectable
equipment with a built-in phono amplifier, by connecting an active
speaker, etc.
Use the pre-amplifier selector switch to set the output, as shown
below.
Connectable
Position of
equipment being
pre-amplifier
used
selector switch
Device with phono
PHONO
input
Device without
LINE
phono input
PC sound card
LINE
Device with USB
LINE
input
*1 An audio adapter (sold separately) may be required to connect the
RCA audio cable to the PC sound card's line input jack.
*2 Use included USB cable instead of RCA audio cable to connect.
When connecting via Bluetooth, set the pre-amplifier selector
•
switch to the LINE position.
Connecting to connectable equipment (active
speakers, amplifiers, etc.)
Connecting to audio source
Align the settings for the pre-amplifier selector switch and connect
the RCA audio cable to an input jack that is compatible with the
connectable equipment you are using (amplifier, receiver, active
speakers, sound card, etc.).
Where to connect the
RCA audio cable
Phono input jack and
ground (earth) terminal of
connectable equipment
AUX or line input jack of
connectable equipment
Sound card's line input
jack*
1
USB input of your
computer*
2
10
• The RCA audio cable's red jack is for the right (R) channel, and the
white jack is for the left (L) channel.
With PHONO input*
Connectable
equipment
(amplifier, etc.)
With PHONO input*
PHONO
L
R
* Depending on the equipment you are connecting, a ground (earth)
terminal may exist near the phono input jack. If this is the case,
connect to it using the ground line from the RCA audio cable. This
will help prevent a low humming noise that might otherwise be heard
during playback.
Without PHONO input
To outlet
To outlet
Without PHONO input
AUX
L
R
Advertisement
Table of Contents
