Setting Pre-Amplifier Selector Switch; Connecting The Device - Audio Technica AT-LP60XBTa User Manual

Preparation for use

Setting pre-amplifier selector switch

This product has a built-in phono equalizer function. You can
use the product even if you do not have a phono amplifier or
connectable equipment with a built-in phono amplifier.
Use the pre-amplifier selector switch to set the output, as
shown below.
Connectable Position of
equipment pre-amplifier
being used selector switch
Device with PHONO
phono input
Device without LINE
phono input
PC sound card LINE
*
An audio adapter (sold separately) may be required to connect the
RCA audio cable to the line input jack of the PC sound card.
When connecting via Bluetooth, using the pre-amplifier selector
•
switch is not necessary.
Where to connect
RCA audio cable
Phono input
jack and ground
(earth) terminal
of connectable
equipment
AUX or line input
jack of connectable
equipment
PC sound card's line
*
input jack
7

Connecting the device

Align the settings for the pre-amplifier selector switch and
connect the RCA audio cable to an input jack that is compatible
with the connectable equipment you are using (amplifier,
receiver, active speakers, sound card, etc.).
• The RCA audio cable's red jack is for the right (R) channel,
and the white jack is for the left (L) channel.
With PHONO
Connectable equipment
(Amplifier, etc.)
With PHONO
PHONO
L R
Without PHONO
To outlet
To outlet
Without PHONO
AUX
L R