Descriptions Of Control Sources; Midi Control Source List; Mono Pressure (Mpress) - Kurzweil K2600 Musician’s Reference

One control source parameters is always global: the Enable parameter on the LAYER page
(Program Editor). When programming this parameter, youÕll see the Main Control Source list
minus the three special MIDI control sources, minus the following local control sources:
Note St
Key St
KeyNum
BKeyNum
AttVel
InvAVel
PPress
BPPress
RelVel
Bi-AVel
VTRIG1
Finally, if youÕve turned on the Globals parameter on the COMMON page in the Program
Editor, the available values for GLFO2, and the values for GASR2Õs trigger will lack the local
control sources listed above, as well as the three special MIDI control sources and the FUN
constants. The available values for GFUN2 and GFUN4 will exclude the same list of local control
sources, but will include the FUN constants.

Descriptions of Control Sources

This section is organized into two sets of descriptions: the MIDI Control Source list, and the rest
of the control sources. The numeral preceding the name of each control source can be entered on
the alphanumeric pad to select the control source directly (press Enter after typing the numeral).
Many of the MIDI control sources are assigned as default values for the control assignment
parameters in the Setup Editor. WeÕll indicate these assignments as they appear, simply by
mentioning that theyÕre the default control source for a control assignment parameter.

MIDI Control Source List

With a few exceptions, the MIDI control sources correspond to the standard MIDI controller
numbers used by every MIDI device.
128
0, 33
OFF
This value eliminates the effect of any control source parameter to which itÕs
assigned.

Mono Pressure (MPress)

Many of the K2600Õs factory programs are assigned to modify parameters such as
pitch, Þlter cutoff frequency, and depth control when MPress messages are received.
The mono pressure (Press) control assignment parameters in MIDI and Setup
modes are set by default to transmit MPress messages when mono pressure
messages are received from a controller.
VTRIG2
RandV1
RandV2
ASR1
LFO1
FUN1
FUN3
Loop St
PB Rate
AtkSt
Rel St
Control Sources
Descriptions of Control Sources
4-3