Parameters For Kb3 Auxfx - Kurzweil K2600 Musician’s Reference

Dist Drive Applies a boost to the input signal to overdrive the distortion algorithm. When
overdriven, the distortion algorithm will soft-clip the signal. Since distortion drive will
make your signal very loud, you may have to reduce the Out Gain as the drive is
increased.
Warmth A lowpass Þlter in the distortion control path. This Þlter may be used to reduce some of
the harshness of some distortion settings without reducing the bandwidth of the signal.
Lo Gain The gain or amplitude of the signal passing through the rotating woofer (low frequency
driver. The control is also available in KB3 AuxFX.
Lo Xover The crossover frequency for the low frequency driver. Lo Xover controls a lowpass Þlter.
Lo HP A highpass Þlter to simulate the band-limiting of a speaker cabinet. The Þlter controls the
lower frequency limit of the output.
Hi Gain The gain or amplitude of the signal passing through the rotating tweeter (high frequency
driver. The control is also available in KB3 AuxFX.
Hi Xover The crossover frequency for the high frequency driver. Hi Xover controls a highpass Þlter.
Hi LP A lowpass Þlter to simulate the band-limiting of a speaker cabinet. The Þlter controls the
upper frequency limit of the output.

Parameters for KB3 AuxFX

Page 1
In/Out In or Out
Page 2
Lo Gain Off, -79.0 to 24.0 dB
Lo Rate -10.00 to 10.00 Hz
Lo Size 0 to 250 mm
Lo Trem 0 to 100%
Lo Beam W 45.0 to 360.0 deg
Page 3
LoMicA Pos -180.0 to 180.0 deg
LoMicA Lvl 0 to 100%
LoMicA Pan -100 to 100%
HiMicA Pos -180.0 to 180.0 deg
HiMicA Lvl 0 to 100%
HiMicA Pan -100 to 100%
Out Gain Off, -79.0 to 24.0 dB
Hi Gain Off, -79.0 to 24.0 dB
Hi Rate -10.00 to 10.00 Hz
Hi Size 0 to 250 mm
Hi Trem 0 to 100%
Hi Beam W 45.0 to 360.0 deg
LoMicB Pos -180.0 to 180.0 deg
LoMicB Lvl 0 to 100%
LoMicB Pan -100 to 100%
HiMicB Pos -180.0 to 180.0 deg
HiMicB Lvl 0 to 100%
HiMicB Pan -100 to 100%
KDFX Reference
KDFX Algorithm Specifications
10-109