Kurzweil K2600 Musician’s Reference page 213

change in amplitude of the sawtooths develops a more gradual slope with smoothing, ending up as
triangle waves when set to 100% smoothing.
Sine
Figure 10-61 Configurable Wave Shapes
Parameters
Page 1
Wet/Dry 0 to 100%wet
Mod Mode L*R or Osc
Page 2
Osc1 Lvl 0 to 100%
Osc1 Shape Sine
Osc1PlsWid 0 to 100%
Osc1Smooth 0 to 100%
Page 3
Sine2 Lvl 0 to 100%
Sine3 Lvl 0 to 100%
Sine4 Lvl 0 to 100%
Sine5 Lvl 0 to 100%
Wet/Dry The amount of modulated (wet) signal relative to unaffected (dry) signal as a percent.
When in ÒL*RÓ mode, the left input will be used as the dry signal.
Out Gain The overall gain or amplitude at the output of the effect.
Mod Mode Switches between the two operating modes of the algorithm. The ÒL*RÓ mode treats the
left and right inputs as the modulator and carrier signals. It does not matter which input is
left and which is right except to note that only the left signal will be passed through as dry.
L*R Pan The output panning of the both wet and dry signals. This control is active only in ÒL*RÓ
mode. -100% is panned fully left, 0% is panned center and 100% is panned right.
Osc1 Lvl The level of the conÞgurable oscillator. 0% is off and 100% is maximum. This parameter is
active only in ÒOscÓ mode.
Saw+ Saw-
PulseWidth
Pulse Tri
Out Gain Off, -79.0 to 24.0 dB
L*R Gain Off, -79.0 to 48.0 dB
L*R Pan -100 to 100%
Osc1 Freq 16 to 25088 Hz
Sine2 Freq 16 to 25088 Hz
Sine3 Freq 16 to 25088 Hz
Sine4 Freq 16 to 25088 Hz
Sine5 Freq 16 to 25088 Hz
KDFX Reference
KDFX Algorithm Specifications
Expon
10-127