Parameters For Lfo Phaser Twin; Parameters For Vibrato Phaser - Kurzweil K2600 Musician’s Reference

Kurzweil k2600: reference guide
Hide thumbs Also See for K2600:
Table of Contents

Advertisement

KDFX Reference
KDFX Algorithm Specifications
Notch/BP
Out Gain
Feedback
Ctr Freq

Parameters for LFO Phaser Twin

Page 1
Notch/Dry
CenterFreq
LFO Depth
Notch/Dry
CenterFreq
LFO Rate
LFO Depth
L/R Phase

Parameters for Vibrato Phaser

Page 1
Wet/Dry
Page 2
CenterFreq
LFO Depth
LFO Rate
Rate Scale
10-62
The amount of notch depth or bandpass. At -100% there is a complete notch at the center
frequency. At 100% the Þlter response is a peak at the center frequency. 0% is the dry
unaffected signal.
The output gain in decibels (dB) to be applied to the Þnal output.
The phaser output can be added back to its input to increase the phaser resonance (left
and right). Negative values polarity invert the feedback signal.
The nominal center frequency of the phaser Þlter (left and right). For a true phaser effect
you may want to modulate these parameters by setting up FX Mods.
0 to 200%
16 to 25088 Hz
0 to 5400 ct
The amount of phaser (wet) signal relative to unaffected (dry) signal as a percent. At 100%
the phaser produces a pair of full notches above and below the center frequency. At 200%
the output is a pure allpass response (no amplitude changes, but phase changes centered
about the center frequency).
The nominal center frequency of the phaser Þlter. When conÞgured for a maximum notch
(Notch/Dry is 100%), the CenterFreq speciÞes the frequency of the peak between two
notches. The LFO modulates the phaser Þlter centered at this frequency.
The rate of the phaser frequency modulating LFO in Hertz.
The depth in cents that the frequency LFO sweeps the phaser Þlter above and below the
center frequency.
The phase difference between the left and right channels of the LFO. A setting of 180
degrees results in one being at the minimum frequency while the other channel is at the
maximum.
-100 to 100%wet
16 to 25088 Hz
0 to 100%
0.00 to 10.00 Hz
1 to 25088x
LFO Rate
0.00 to 10.00 Hz
L/R Phase
0.0 to 360.0 deg
Out Gain
Off, -79.0 to 24.0 dB
Bandwidth
0.010 to 5.000 oct
L/R Phase
0.0 to 360.0 deg
In Width
-100 to 100%

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents