Pitcher; Shaper - Kurzweil K2600 Musician’s Reference

KDFX Reference
KDFX Algorithm Specifications
All other parameters
Reverb
The reverbs offered in these combination effects is MiniVerb. Information about it can be found in the
MiniVerb documentation. Parameters associated with this reverb begin with Rv.
MiniVerb
Rv Type
Rv Time
Rv DiffScl
Rv SizeScl
Rv PreDlyL

Pitcher

The pitchers offered in these effects are the same as that found in its stand alone version. Review the
Pitcher section for more information. Parameters associated with this effect begin with Pt.
Parameters for Pitcher
Pt Pitch
Pt Offset
Pt Odd Wts
Pt PairWts
Pt 1/4 Wts
Pt 1/2 Wts

Shaper

The shaper offered in these combination effects have the same sonic qualities as those found in VAST.
Refer to the section on shapers in the MusicianÕs Guide for an overview. Parameters associated with this
effect begin with Shp.
This KDFX shaper also offers input and output 1 pole (6dB/oct) lopass Þlters controlled by the Shp Inp LP
and Shp Out LP respectively. There is an additional output gain labeled Shp OutPad to compensate for the
added gain caused by shaping a signal.
Parameters for Shaper
Shp Inp LP
Shp Amt
Shp Out LP
Shp OutPad
10-78
causing the image to collapse into a center point source. A setting of 100%
causes the left and right channels to swap each regeneration, which is also
referred to as Òping-pongingÓ.
Refer to 4-Tap Delay BPM documentation.
Hall1
0.5 to 30.0 s; Inf
0.00 to 2.00x
0.00 to 4.00x
0 to 620 ms
C-1 to G9
-12.0 to 12.0 ST
-100 to 100 %
-100 to 100 %
-100 to 100 %
-100 to 100 %
16 to 25088 Hz
0.10 to 6.00 x
16 to 25088 Hz
Off; -79.0 to 0.0 dB
Rv Density 0.00 to 4.00x
Rv HF Damp 16 to 25088 Hz
Rv PreDlyR 0 to 620 ms