Response Of Lfo Phaser Twin With Wet/Dry Set To 100%.; Parameters For Lfo Phaser; Parameters For Singlelfo Phaser - Kurzweil K2600 Musician’s Reference

KDFX Reference
KDFX Algorithm Specifications
when set to 0% and at 200%, the signal is a pure (wet) allpass response. LFO Phaser Twin does not have
Out Gain or feedback parameters.
Figure 10-22
The Vibrato Phaser algorithm has a couple of interesting twists. The bandwidth of the phaser Þlter can be
adjusted exactly like a parametric EQ Þlter. The built in LFO can be made to run at audio rates by
multiplying the LFO Rate parameter with the Rate Scale parameter. Running the LFO at audio rates
produces strange frequency modulation effects. The In Width controls how the stereo input signal is
routed through the effect. At 100% In Width, left input is processed to the left output, and right to right.
Lower In Width values narrow the input stereo Þeld until at 0%, the processing is mono. Negative values
reverse left and right channels. The dry signal is not affected by In Width. As described earlier setting Wet/
Dry to 50% will produce a full notch. At -50% Wet/Dry, you get a bandpass.

Parameters for LFO Phaser

Page 1
Wet/Dry
Fdbk Level
Page 2
CenterFreq
FLFO Depth
FLFO Rate
FLFO LRPhs

Parameters for SingleLFO Phaser

Page 1
Wet/Dry
Fdbk Level
10-60
Gain
0 dB
-20
-40
10 Hz

Response of LFO Phaser Twin with Wet/Dry set to 100%.

0 to 100%wet
-100 to 100%
16 to 25088 Hz
0 to 5400 ct
0.00 to 10.00 Hz
0.0 to 360.0 deg
0 to 100%wet
-100 to 100%
100 1000 10k
Freq
Out Gain Off, -79.0 to 24.0 dB
NotchDepth -79.0 to 6.0 dB
NLFO Depth 0 to 100 %
NLFO Rate 0.00 to 10.00 Hz
NLFO LRPhs 0.0 to 360.0 deg
N/F Phase 0.0 to 360.0 deg
Out Gain Off, -79.0 to 24.0 dB