Parameters For Kb3 Fxbus - Kurzweil K2600 Musician’s Reference

KDFX Reference
KDFX Algorithm Specifications
rotation before you hear changes to tremolo when parameter values are changed. Negative microphone
angles take a longer time to respond to tremolo changes than positive microphone angles.
Figure 10-48
You can control resonant modes within the rotating speaker cabinet with the Lo and Hi Resonate
parameters. For a realistic rotating speaker, the resonance level and delay excursion should be set quite
low. High levels will give wild pitch shifting.

Parameters for KB3 FXBus

Page 1
In/Out
VibChInOut
Vib/Chor
Page 2
RotoInOut
Lo Gain
Lo Xover
Lo HP
In/Out
Out Gain
VibChInOut
Vib/Chor
Roto InOut
10-108
(i)
Acoustic beams for (i) low frequency driver and (ii) high frequency driver
In or Out
In or Out
V1
In or Out
Off, -79.0 to 24.0 dB
16 to 25088 Hz
16 to 25088 Hz
When set to ÒInÓ, the algorithm is active; when set to ÒOffÓ the algorithm is bypassed. For
the entire algorithm to be active, KB3 AuxFX must also be active.
The overall gain or amplitude at the output of the effect. For distortion, it is often
necessary to turn the output gain down as the distortion drive is turned up.
When set to ÒInÓ the vibrato/chorus is active; when set to ÒOutÓ the vibrato/chorus is
bypassed.
This control sets the Hammond B3 vibrato/chorus. There are six settings for this effect:
three vibratos ÒV1Ó, ÒV2Ó, ÒV3Ó, and three choruses ÒC1Ó, ÒC2Ó, ÒC3Ó
When set to ÒInÓ the rotary speaker is active; when set to ÒOutÓ the rotary speaker is
bypassed. By bypassing the rotary effect in KB3 FXBus, only the crossover Þlters are
bypassed. You must also bypass KB3 AuxFX to completely bypass the rotary speakers.
Likewise, for the entire rotary to be active, KB3 AuxFX must also be active.
(ii)
Out Gain Off, -79.0 to 24.0 dB
Dist Drive 0 to 96 dB
DistWarmth 16 to 25088 Hz
Hi Gain Off, -79.0 to 24.0 dB
Hi Xover 16 to 25088 Hz
Hi LP 16 to 25088 Hz