Editing A Setup For Kb3 Control - Kurzweil K2600 - MUSICIANS GUIDE REV A PART NUMBER 910330 CHAP 20 Manual

a value of -10800 cents. Move your MIDI controllerÕs Mod Wheel to bring out the snareÕs high
end.
Example 6

Editing a Setup for KB3 Control

1. Go to Setup mode, and select 97 ControlSetup.
2. Press Edit to enter the Setup Editor.
3. Press the more> soft button, then press the FOOTSW soft button.
4. Use the cursor buttons to highlight TapTempo (itÕs the value of the Dest parameter for
5. On the alphanumeric button pad, press 6 8 Enter. This changes the value to LegatoSw,
6. Press the more> soft button, then press the RIBBON soft button.
7. Highlight AuxBend2 (itÕs the value of the Dest parameter for SmRib).
8. On the alphanumeric button pad, press 1 6 Enter. This changes the value to Ctl A, which is
9. Highlight MPress (itÕs the value of the Dest parameter for SmPrs).
10. On the alphanumeric button pad, press 1 7 Enter. This changes the value to Ctl B, which is
11. Highlight AuxBend1 (itÕs the value of the Dest parameter for LgRibÑor Sect1 if the large
12. On the alphanumeric button pad, press 1 8 Enter. This changes the value to Ctl C, which is
13. Press the SWITCH soft button.
14. Highlight ArpSw (itÕs the value of the Dest parameter for PSw1ÑButton 9 above the Pitch
15. On the alphanumeric button pad, press 6 9 Enter. This changes the value to FrezPd, which
16. Highlight MIDI29 (itÕs the value of the Dest parameter for PSw2ÑButton 10 above the
17. On the alphanumeric button pad, press 7 0 Enter. This changes the value to MIDI70.
18. Press Exit. The K2600 will ask you if you want to save the setup. Press the Rename soft
19. Press either Chan/Bank buttons until the KbdNaming parameter in the top line of the
FtSw4).
which is MIDI 68 (for VAST programs, MIDI 68 will now control Legato Switch, but for
KB3 programs, it will switch between slow and fast rotary speaker effect).
MIDI 16.
MIDI 17.
ribbon is conÞgured in three sections).
MIDI 18.
Wheel).
is MIDI 69.
Mod Wheel).
button.
display shows a value of Adv. This lets you rename the setup by playing notes (in this
Programming Examples
20-11