HPE Synergy 12000 Frame Maintenance And Service Manual page 116

Item Item Description Description
3 SFP+ Image Streamer port
LEDs
4 Fibre Channel (FC) mode
LED
5 Ethernet mode LED
6 PID mode LED
7 Link/Activity mode LED
8 Health LED
9 Mode button
10 UID LED
1
Status Status
Left LED Left LED
Link/Activity mode:
Off = No Link
Solid green = Ethernet linked at 10Gb
PID:
Off = Not configured
Solid blue = Port ID
Solid green = Configured for Ethernet
Solid red = Error
Ethernet:
Off = Not Ethernet
Solid green = Configured for Ethernet
Fibre Channel:
Always off
Right LED Right LED
Link/Activity mode:
Off = No activity
Flashing green = Activity at 10Gb
PID:
Always off
Ethernet:
Always off
Fibre Channel:
Always off
Solid green = FC mode is selected.
Solid green = Ethernet mode is selected.
Solid green = PID mode is selected.
2
Solid green = Link/Activity mode is selected.
Solid green = Normal
Flashing amber = There is a fault condition
Flashing red = Critical fault detected
Solid red = No power present
Press and hold the Mode button for more than 5 seconds to reset.
Solid green = There are four LEDs that indicate the operating mode for the
Port LEDs. The operating mode is selected by pressing the Mode button on
the front panel. The LED mode state determines which of the four Mode
LEDs is lit.
Solid blue = Activated
Flashing blue = Firmware upgrade in progress
Off = Deactivated
HPE Virtual Connect SE 100Gb F32 Module for HPE Synergy LEDs and buttons 116