Table of Contents
Advertisement
DP1100
1.3.3
LEDs
The 7 colored LEDs on the DP1100 front panel are shown in the following
figure:
EXT
TRIG
The first two LEDs refer to scan head 1 connected to the decoder. The next
two LEDs refer to scan head 2 for H2 models.
The LEDs indicate:
EXT
YELLOW LED indicates the code presence sensor is active (for
TRIG
details refer to the section "On Line Mode" in the Help On Line of
the Winhost utility program).
GOOD
RED LED is used to signal successful barcode decoding. It is also
READ
used in Test mode to signal the decoding (for details refer to the
section "LED Threshold" in the Help On Line of the Winhost utility
program).
TX
GREEN LED indicates transmission of data relative to the code
DATA
or to programming running on the main serial interface.
RX
GREEN LED indicates reception of data relative to the code or to
DATA
programming running on the main serial interface.
POWER
RED LED indicates the decoder is powered.
ON
1.3.4
On/off Switch
The on/off switch can be used to turn the device off if an emergency on the
system occurs. The device can also be turned off for working on the internal
cabling or other particular maintenance.
1.4 - General features
1
GOOD
EXT
READ
TRIG
Figure 1.1 - DP1100 LEDs
2
GOOD
TX
READ
DATA
DATALOGIC
RX
POWER
DATA
ON
Advertisement
Table of Contents
