Table of Contents
Advertisement
DATALOGIC
1.3.5
Removable Glands Panel
To make installation and replacement easier, the DP1100 is made up of two
parts:
1) the body of the device with all standard electronic components and
optional boards
2) the removable panel housing the glands for all external communication
cables
This panel houses four glands for I/O and serial interface connections.
1.3.6
Communication Interfaces
The DP1100 is equipped with the following serial communication types for its
main serial interface:
EIA RS232
EIA RS485 POLLED
The DP1100 also supports an RS232 auxiliary interface to be connected to
another host computer or for particular layouts such as Pass Through.
Details regarding the connections and use of the interfaces are given in
chapter 2 "Installation".
1.3.7
Inputs
PS1 presence sensor inputs (and PS2 for H2 models), allow code reading
and consequent decoding to be synchronized with an external sensor, as in
On Line operating mode.
During the PRESENCE SENSOR active phase, the yellow LED on the front
of DP1100 is activated and VIDEO and SCAN signals for decoding are
acquired from the scanner.
PS1AUX (and PS2AUX for H2 models) are auxiliary presence sensor inputs
used to indicate to the decoder what code to store as the verifier code. For
further details refer to the section "Store Verifier HW" in the Winhost Help On
Line.
EIA RS485 NON POLLED
20 mA CURRENT LOOP
DP1100
General features - 1.5
Advertisement
Table of Contents
