Managing Protocols - EDAN SE-12 Series User Manual

SE-12 Series Electrocardiograph User Manual
3. You should test whether the treadmill is controlled by SE-12 Express well when
SE-12 Express is connected to the treadmill for the first time.
4. Do not stand on the treadmill when testing it for the first time.
5. Before the exercise test, be sure to be familiar with the user manual of the treadmill or
the ergometer.
6. If you have any questions about the operation, please contact us or your local
distributor.

11.5 Managing Protocols

Select Protocol on the System Setup screen, and press Enter to open the Protocol Manager
(treadmill or ergometer) screen.
NOTE: The Protocol Manager (treadmill or ergometer) screen can be displayed
according to the Device Type setting you configure in the General Information
Setup window. Managing treadmill protocols is taken for an example in this
manual; therefore there is no further description for managing ergometer
protocols.
1. Adding Protocols
Select Add on the Protocol Manager screen to display the Edit Protocol dialog box.
Enter the new protocol name in the Protocol Name textbox, and then enter the stage information
of every stage, including the time, speed and grade. After that, press Enter to confirm.
NOTE:
1) When Time of a stage in the exercise phase is set to 00, this stage and its following
stages in the exercise phase will not be carried out.
2) "1/3" in the Add Protocol window stands for "the current page/ the total pages".
3) Pressing Shift + Left/Right can turn pages in the on the Add Protocol window.
2. Editing Protocols
Select a protocol on the Protocol Manager screen by pressing the Up or Down arrow, and select
Edit to display the Edit Protocol dialog box.
Edit the protocol name or the stage information of every stage, including the time, speed and
grade. After that, press Enter to confirm.
NOTE: For the Bruce or Modified Bruce protocol, only the stage information of the pretest
and recovery phases can be edited.
Operation Instructions for Exercise ECG
- 73 -