Konica Minolta Magicolor 7300 User Manual page 126

How do I replace the media separator roller for Tray 2 and
optional Tray 3/4?
The media separator roller should also be replaced at the same time that the
media pickup roller is replaced. The following procedure describes the
replacement of the media separator roller for the standard media tray (Tray 2)
and the optional media trays (Trays 3 and 4).
1
Remove the two screws from the
outer-right side of the tray, as
shown, and then remove the media
separator roller.
2
Take out the new media separator roller.
Place the used media separator roller in the packing for the new
media separator roller.
3
Attach the new media separator
roller to the tray.
Do not throw away the box and
plastic bag that the new media
separator roller was packed in.
They will be reused to pack the
used media separator roller.
Attention
Contact toner_recycle@bpus.konicaminolta.us for recycling
availability. Do not throw away.
4
Close the tray.
118 Replacing Media Pickup and Separator Rollers