Installing Accessories - MINOLTA-QMS Magicolor 3100 Installation Manual

3
Fan a stack of approximately 100
sheets of paper.
A fill limit mark is provided on the inside
of the tray. The multipurpose media tray
holds approximately 100 sheets of 20 lb
bond (75 g/m²) paper.
Attention
Do not overfill the tray. The paper should fit easily between the
guides. Improperly adjusted guides may cause poor print quality,
media jams, or printer damage.
4
Load the paper face-down with its top
and short edge toward the printer.
Often, an arrow on the media package
label indicates the printing-side of
the media.
5
Make sure the media fits properly in
the tray.
For further information about loading and
using media, refer to chapter 2, "Using
Media," in the User's Guide .

Installing Accessories

Attention
Installing accessories always requires that the printer and accessories
are turned off and unplugged during installation.
If you purchased any additional printer accessories, then install them now.
If installation instructions are included with the accessory, follow them. If
not, instructions are included in the User's Guide . A complete list is in
"Accessories and Consumables" on page 39. Contact your local vendor or
www.minolta-qms.com for purchase information.
14 Installing Accessories