Plugging In/Turning On The Printer - MINOLTA-QMS Magicolor 3100 Installation Manual

Plugging in/Turning on the Printer

1
Make sure the printer is turned off.
2
Plug the printer power cord into the
printer and into a dedicated, grounded,
surge-protected electrical outlet.
Attention
Do not overload the outlet.
3
Turn on the printer.
5 "
In compliance with UL guide-
lines, "The appliance inlet is
considered to be the main
disconnect device."
After approximately a 6-minute
warmup (assuming normal tempera-
ture and humidity), your printer prints a
startup page and displays "IDLE" on the message window.
5 "
This 6-minute warmup happens only when a new imaging unit
has been installed. Normal time to warm up is approximately
1½ minutes.
If "IDLE" is not displayed in the message window after the printer is
turned on and warmed up, recheck the setup. If the startup page doesn't
print or the print quality is not good, skip ahead to "Troubleshooting" on
page 37.
The printer automatically switches to power-saving (energy-saving) mode
after 30 minutes of inactivity. You can change the number of minutes before
the printer switches to power-saving mode in the Administration/Engine/
Energy Saver menu.
Plugging in/Turning on the Printer
15