Table of Contents
Advertisement
HO CHIER
The axial micro-switches are fixed on the micro-switch fixing plate gold, and the
two fixing nuts are locked inside and outside. Please pay attention to the position
after the fixing nut is locked.
(4)更換後請先 從 PLC/F 畫 面診斷信號， 以手輪進給模式，測 試軸向原
點微動 開關信號 ON/OFF 情形，以及微動開關碰觸擋塊後之作用距離。
更換後請先從 PLC/F 畫面診斷信號，以手輪進給模式，測試軸向原點
微動開關信號 ON/OFF 情形，以及微動開關碰觸擋塊後之作用距離 .
After the replacement, please diagnose the signal from the PLC/F screen first, and
test the axial direction in the hand wheel feed mode. Point micro switch signal
ON/OFF condition, and the action distance of the micro switch after touching the
block.
(5)如有更換原點微動開關時，更換後，請重新作機械原點復歸後，必須
重新校正工件零點到機械原點距離。
After preparing the welding torch for electric heating, click and keep on the solder
joint and remove the LED bulb.
F.過濾網
Suction Line Filter
(1)電氣箱上之過濾網，請每個月定期維護清潔，可以壓縮空氣清潔，清潔
時請拆下後再實施。電氣箱上之過濾網，請每個月定期維護清潔，可以
壓縮空氣清潔, 清潔時請拆下後再實施。
The filter on the electrical box should be cleaned regularly every month. It can be
cleaned with compressed air. Please remove it before cleaning.
(2)切削液水箱上的鐵屑過濾網，每週定期清潔。
The iron filings on the cutting fluid tank need to be cleaned regularly every week.
G.電氣箱、操作箱內部維護保養清潔
Maintenance and cleaning of electrical box and control box.
(1)檢測保險絲是否 BROKEN。
Check if the fuse is BROKEN.
(2)檢查電路接頭固定螺絲是否鬆動。
Check if the circuit connector fixing screws are loose. Check if the circuit connector
34
Advertisement
Table of Contents
