Removing A Simm - QMS 860 User Manual

Removing a SIMM

If all four of the SIMM connectors are filled and you want to install
more memory (for example, if you want to replace a 4 MB SIMM
with an 8 MB SIMM), a SIMM must be removed. The following
section explains this procedure. The previous section, "Installing a
SIMM," explains the installation instructions. You can remove a
SIMM from and install a SIMM in any SIMM connector as long
as either a 4 MB or an 8 MB SIMM occupies RAM0, the SIMM
connector farthest from you. Also, you must make sure that there
is a total of at least 12 MB of RAM installed.
CAUTION: Eliminate static by putting on the anti-static wristband
provided with your printer option accessory kit and grounding it to
any base metal surface (such as the bottom of your telephone).
Avoid walking around after grounding yourself because your body
may build up static and you will have to repeat the grounding
process. If you obtained the SIMM from someone other than a
QMS vendor and do not have an anti-static wristband, before
removing the SIMM from the anti-static bag ground yourself by
touching the bag and any base metal surface (such as the bottom of
your telephone). Handle the SIMM carefully and preferably by the
edges only.
WARNING:
before taking the cover off the printer.
ACHTUNG:
Sie den Netzstecker heraus bevor Sie die Druckerabdeckung
öffnen.
1. Follow the steps in the "Removing the Printer and Controller
Board Covers" section of this chapter to access the controller
board.
P r i n t e r O p t i o n s
Turn off the printer and unplug the power cord
Bitte schalten Sie den Drucker aus und ziehen
Chapter 8
8 - 3 8