QMS 860 User Manual page 122

Chapter 4
Quick Config
Paper Size
Resolution
Quick Config uses the resolution and the paper size to configure
the printer's frame buffer memory for the most complicated
conditions in a particular environment. The printer sets values that
are guaranteed to work with the amount of RAM currently installed
in the printer.
When using Quick Config. you should select the most demanding
requirements of the printer. For example, if jobs are printed
primarily on 11" x 17" paper, but occasionally jobs are printed on
8.5" x 11" paper, then select 11" x 17" paper size.
K Mem for Spool (5 digits; default 00192; range 00192-06144)
Prerequisite
Number of kilobytes of RAM allocated to the spooling buffers.
This memory client stores incoming data from the various
interfaces until it is ready to print. This memory client is listed as
Host Input on the status page. When the sum of the Min K Spool
for all communications interfaces is less than K Mem For Spool,
memory is allocated as follows:
1. Interfaces with Min K Spool (in the Administration /
Communications menu) value greater than zero to receive their
specified allocation.
2. Half of the remaining memory is equally distributed among any
interfaces with a Min K Spool value of zero.
4 - 4 2
(default letter; range letter, A4, 11 x 17, A3, legal, B4,
A5, B5, A6, B6, executive, universal)
(default 600; range 300, 600)
value must be greater than the sum of the Min K Spool
for all installed and enabled communications
interfaces.
P r i n t e r C o n f i g u r a t i o n