Table of Contents
Advertisement
1.
Follow the steps in the "Removing Printer and Controller
Board Covers" section of this chapter to access the controller
board.
2.
Remove the SIMM from the anti-static bag.
3.
Hold the SIMM at a 45° angle to the controller board, with the
notch on the left side. Slide the SIMM into any open SIMM
connector on the controller board (fig. 8.22). Push gently to
make sure the board is properly seated onto the connector.
Fig. 8.22 Insert SIMM into SIMM Connector
NOTE: You can install a SIMM in any SIMM connector as long
P r i n t e r O p t i o n s
as either a 4 MB or an 8 MB SIMM occupies RAM0, the
SIMM connector farthest from you.
Chapter 8
45
8 - 3 6
Advertisement
Table of Contents
