Installation; Initial Setup Steps - Gram BioCompact II Instructions For Use Manual

Installation

Initial setup steps

Due to safety and operating considerations, the
cabinet must not be used outdoors.
The cabinet should be installed in a dry and
sufficiently ventilated area.
To ensure efficient operation, the cabinet should
not be installed in direct sunlight or close to heat
sources.
The cabinet interior must not be exposed to
corrosive atmospheres.
Avoid placement of the cabinet in a chloric/acidic
environment due to risk of corrosion.
The cabinet is shipped with a protective film that
should be removed prior to use.
WARNING –
Potential electrostatic hazard
Removing protective packaging and
film may cause electrostatic discharge.
Protective packaging and film shall not be
removed in ATEX zones.
10 10
Ambient operating temperature range
Minimum
ambient
Cabinet
operating
temperature
BioCompact II 210, 310, 410, 210/210, 310/210
RR with solid door
RR with glass door
RF
BioCompact II 610
RR with solid door
RR with glass door
RF
Clean the cabinet with a mild soap solution prior to
use.
The cabinet is only allowed to lay down for very
short durations (for instance handling through a
doorway). If the cabinet has been laying down, the
cabinet must stand up-right for at least 24 hours
prior to use. This enables oil in the compressors to
run back into place.
Maximum
ambient
operating
temperature
+10ºC +35ºC
+10ºC +32ºC
+10ºC +35ºC
+10ºC +43ºC
+10ºC +38ºC
+10ºC +43ºC