Streamer Unit - Daikin MCK70YVM Operation Manual

Streamer Unit

Soak
If the streamer lamp blinks (if stains are an issue, they can be removed even if the streamer lamp is not
blinking.)
1.
Remove the power supply plug.
2.
Remove the front panel.
3.
Remove the streamer unit.
Streamer unit
Grip
Hold the centre of
the grip and pull out
4.
Soak in lukewarm or room temperature water.
(About 1 hour)
• Carry out this procedure in a place where splashing
water will not cause trouble, such as a bathroom or
kitchen sink.
• If dirt buildup is severe, leave the part soaking in
lukewarm or room temperature water mixed with
kitchen-use neutral detergent.
• Observe the quantities indicated in the directions/
warnings on the kitchen-use neutral detergent when
using detergent.
5.
Remove dirt with a cloth, soft brush or cotton
bud.
CAUTION
When wiping or scrubbing, use rubber gloves.
(Your hands may be cut by metal parts or the
streamer unit needle)
• Carry out this procedure after soaking and before drying.
• Make sure that no fuzz or fibres from the cloth remain.
(Malfunction may result)
• Do not use powder detergent or alkaline or acidic
detergent. Do not scrub with a hard scrubbing brush.
(Deformation, damage, and rusting of metal parts may result)
• Do not remove the screws. (Malfunction may result)
• Use a cotton bud or a soft cloth to clean the inner
plastic and metal parts.
Use rubber
gloves
Cloth
Cotton bud
Wipe
►Page 13
Wipe off
CAUTION
Do not wipe the needles forcefully. (Deformation/
damage of the needles and reduced performance
may result)
• If there is dirt on the needle, soak a soft object such
as a cotton bud in water or kitchen-use neutral
detergent and wipe off the dirt lightly.
Use rubber
gloves
Cotton bud
6.
Rinse with water and dry in the shade in a
well-ventilated area. (About 1 day)
• If detergent remains, the streamer lamp may blink
even after cleaning, so rinse thoroughly with water.
• The plastic parts may suffer discolouration or
deformation if exposed to direct sunlight.
• If even a small amount of water remains, the
streamer lamp may blink even after cleaning, so dry
well in the shade.
7.
Attach the streamer unit.
Grip
Hold the centre of
the grip and insert
slowly and fully
Streamer unit
8.
Attach the front panel.
Note
If the unit is operated without the streamer unit attached,
there is no problem in terms of safety, but the performance
will deteriorate.
Attach the streamer unit before use.
Maintenance
Wipe off dirt
Wipe the needles
lightly from the
base to the tip
Dirt
Cotton bud
►Page 14
32