Table of Contents
Advertisement
16
Using the Main Menu
16.1.3 Configuring Audio Recording
The system supports audio recording on channels 1~4.
NOTE
You must connect BNC audio input devices to the system to use audio recording or you must have an
MPX camera that supports audio.
To configure audio recording:
1. From the Main Menu, click
2. Under Channel, select the channel you would like to configure.
3. Check the left Audio/Video checkbox to enable audio recording. Check the middle
checkbox to enable audio streaming to remote devices (such as a smartphone). Check
the right checkbox to enable video streaming to remote devices.
4. Under Audio Format, select the format that will be used to record audio. G711a is
recommended.
5. Under Audio Source, select Normal to use the system's BNC audio input.
6. Click OK to save changes.
16.1.4 Configuring Snapshot Recording Settings
The system can be set to record snapshot images when a camera detects motion. These
snapshots can be viewed through the Search menu or can be attached to email alerts and
push notifications. The Snapshot tab in the Recording menu controls the quality and re-
cording parameters for each camera.
NOTE
In order to enable Snapshot recording, the following menu options must be configured:
•
The Snapshot schedule must be enabled for times that you would like to save snapshots. See 16.3.16
Configuring the Snapshot Schedule, page 62.
•
Snapshot recording must be enabled for motion detection in the Event menu. See 16.3.7 Configuring
Motion Detection, page 54.
To configure snapshot recording settings:
1. From the Main Menu, click
2. Under Snap Number, select the number of snapshots the system will take when the
snapshot button is pressed.
#LX400057; r. 1.0/24460/24461; en-US
and select Recording>Recording.
and select Recording>Snapshot.
42
Advertisement
Table of Contents
