Sencore AG 6000 User Manual page 61

3.2.15.4 SDI Audio Embedding
The Audio selection tab allows for configuration of SDI embedded audio settings based
on the settings chosen from section 3.2.12. The AG 6000 comes standard with the ability
to decode two audio services. With additional licensing the AG 6000 can handle up to
four unique audio services. When licensed for four audio services, the user will have four
audio pairs available to embed audio in the SDI. These two SDI groups provide inclusion
of four audio pairs, with two pairs to each group. All audio pairs share the same options.
Note: From section 3.2.12, if Audio 1's "Processing Mode" is set to "Discrete", then
Audio 2 will only be capable of "PCM", and Audio 3 and Audio 4 will only be capable of
"Pass-through".
Setting Range
Group 1-2 Disabled
Pair 1-2 Audio 1-4 PCM
Audio 1-4 Pass-through
Lf/Rf, C/LFE, Ls/Rs,
Ch1/Ch2, Ch3/Ch4,
Ch5/Ch6, Ch7/Ch8
Page 61 (122)
AG 6000 – User Manual
Primary Audio Selection Tab
Description
Assigning a PCM audio to a Group Pair will embed
the downmixed four channel audio. Assigning
Pass-Through to a Group Pair will embed
unprocessed compressed audio in the SDI VANC.
Selecting Off disables the Group Pair completely.
Also present are the options for decoding Dolby
5.1