Sencore AG 6000 User Manual page 100

FEC uncorrect packet
counter increased
Fan Speed Below Lower
Limit
IP Loss Error
ISI Not Found
Input Video Unsupported
LNB Power Error
Link Loss Error
Loss of Carrier Lock
Low Level
Low Mer
MPE Data Extraction
Error
Multistream Mode Input
Mismatch
No Services Detected
PID Filter Overflow Error
PID Filter Selection Not
Present
RTP Reception Error
ES Sync Error Condition
SCTE35 Heartbeat
Timeout
Selected Audio PID Not
Present
Selected PCR PID Not
Present
Selected Video PID Not
Present
Service Not Found
Page 100 (122)
AG 6000 – User Manual
Packets in incoming IP stream cannot be repaired with forward
error correction.
Cooling fan in the AG 6000 has failed.
No IP packets have been received by the MPEG/IP card for two
seconds.
ISI value defined by the user is not found in the incoming
multistream signal.
Native format of incoming video is not a supported video format.
LNB Power is enabled but the AG 6000 is detecting power is
being provided by another source, there is excessive current
drain or an overvoltage has occurred.
Physical IP link is not present on the MPEG/IP card.
Receiver carrier lock source is lost.
8VSB/QAM RF Level is below the user settable threshold
8VSB/QAM MER is below the user settable threshold
MPE Data could not be extracted from the incoming stream.
Multistream Mode is enabled and input signal is not multistream
capable or Multistream Mode is disabled and input signal is
multistream capable.
Service Lock service selection mode is enabled but no services
are present in the active input transport stream.
Configured PID Filter TS rate is too low.
Selected Service or PID is not present for inclusion in the output
PID filter TS.
Uncorrectable out of order or duplicate packets are present in
incoming IP stream.
One of the in-use elementary streams is not synchronized to the
PCR
The time since the last received SCTE35 message has passed
the designated heartbeat timeout.
PID Locked mode is set as service selection mode and audio
PID defined by user is not present in the incoming stream.
PID Locked mode is set as service selection mode and PCR
PID defined by user is not present in the incoming stream.
PID Locked mode is set as service selection mode and video
PID defined by user is not present in the incoming stream.
Service Lock service selection mode is enabled but service
defined by user is not present in the incoming stream.