Siemens SITRANS F Instruction Manual page 76

Section 2
NOTES
Mount the transducers using the selected mode (direct or reflect). Please refer to the trans-
z
ducer mounting procedures detailed in Section 3.
When using a mounting track or a spacer bar in reflect mode, locate the first transducer
z
at the Reference Index and the second transducer at the recommended Number Index.
If you are mounting the transducers independently, you must use the recommended dis-
z
tance; Ltn to space the transducers.
You must use the proper sonic coupling compound. See "Recommended Sonic Coupling
z
Compounds" in Section 5 for appropriate type and part number.
The pipe must be completely filled with a liquid, which can be either flowing or at zero
z
flow.
After transducers are properly mounted, the flow computer completes its Initial Makeup command and
the [Install Completed?] menu cell appears.
To access the [Install Completed?] option list, press the <Right Arrow>.
Press <Down Arrow> and scroll to the [InstallCompleted?] menu cell and then press <ENT>
(unless otherwise directed to do so by the Technical Service Department).
Press <ENT>. The [Install Completed?] menu cell will indicate [Yes] after the FUE1010EN is
successfully installed.
Siemens 2 Channel
Key [Install] after mounting transducers
Transducer Model
Transducer Size
Xdcr Mount Mode
Spacing Offset
Number Index
Spacing Method
Ltn Value (in)
Install Completed?
Empty Pipe Set
Zero Flow Adjust
Pick/Install Xdcr
[1] SITE1
1011 Universal
B3
Direct
Minimum
4
Track 1012TP
0.217
No
Channel Not Setup
Channel Not Setup
Siemens 2 Channel
Key [Install] after mounting transducers
Transducer Model
Transducer Size
Xdcr Mount Mode
Spacing Offset
Number Index
Spacing Method
Ltn Value (in)
Install Completed?
Empty Pipe Set
Zero Flow Adjust
Pick/Install Xdcr
2-22
1010ENFM-3B
[1] SITE1
1011 Universal
B3
Direct
Minimum
4
Track 1012TP
0.217
Yes
Channel Not Setup
Channel Not Setup