The Stripchart Setup Menu - Siemens SITRANS F Instruction Manual

Section 2
Press to move to the [Indicated Rate] field, then
Use the numeric keys to type a flow rate for point #1, then press
NOTE: Enter absolute value of the flow. Flow rate is not direction sensitive. The same calibra-
tion applies to both negative and postitive flow rates.
The highlight moves to the [% Correction] field for point #1. Press
entry.
Use the numeric keys to type the required % correction for point #1.
Press . The highlight returns to the [Point #] field.
ENT
To enable numeric entry press
Press . The cursor moves to the point #2 [Indicated Rate] field.
ENT
Use the numeric keys to type a flow rate for point #2. The value entered here
must be of a greater magnitude than the value entered for point #1.
Press . The cursor moves to the [% Correction] field.
ENT
To enable numeric entry press
Use the numeric keys to type the required % correction for point #2. Press
Repeat this procedure for all required calibration points. After entering the last
Flow Calibration Point press
2.8

THE STRIPCHART SETUP MENU

This menu becomes available after picking a Meter Type and Measurement Channel.
Use Stripchart Setup to select a data category, the type of scaling and the update interval for the on-
screen stripchart display. You can also clear the stripchart screen.
Use this menu cell
to select a data
item to display on
the stripchart.
Use this menu cell
to select whether
the stripchart
shows data as
either a rate or a
percentage of
span.
then type [2] (for the second calibration point).
to exit MultiPoint calibration.
Siemens 2 Channel [1]
Select Data Units or Percent Display
Select Data
Data Display
Time Base
Stripchart Clear
Use this menu cell
to clear the current
stripchart.
Stripchart Setup
2-53
to enable numeric entry.
ENT
SITE1
LiquIdent
Data Rate Units
1 second
Yes
1010ENFM-3B
to enable numeric
ENT
Use this menu cell
to select an update
interval for the
stripchart.