Relay Option List; Analog Input Setup - Siemens SITRANS F Instruction Manual

Section 2
Not Used
Power Off
High Flow
Low Flow
Flow Alarm
Fault Alarm
Spacing
Empty
Aeration
Reverse Flow
BatchTot
Pos Total
Neg Total
High Energy
Low Energy
Energy Postot
Energy Negtot
Td
Ts
High CE*
Low CE*
Soft Fault
*Used with CE Method only. Unit must have Analog Input capability.
To assign functions to Relay 1:
To access the [Relay] option list press
To move the cursor to the desired Relay assignment press
To store selection press
Repeat procedure for Relay 2.
2.10.3 ANALOG INPUT SETUP (optional function)
NOTE: Some versions of the FUE1010EN have the ability to read analog inputs signals. The
[Analog Input Setup] menu cell is not displayed if your model's operating system does
not include this facility.
The Analog Input Setup function assigns an active analog input to a measurement channel/path. The
meter provides four DC current input ports for single channel units and two DC current input ports for
Dual Channel units. These ports can be assigned to represent supply temperature, return temperature
or power consumption (see table below). The DC current input ranges from a zero level of 4 mA to a full
scale of 20 mA. The [Analog Input Setup] menu cell allows you to enable this port and then span it to any
desired scaling.
NOTE: Refer to the Installation Drawings or I/O Module markings for the locations of these in-
puts and wiring procedures.

RELAY OPTION LIST

Not Active
Power Off alarm occurs when power fails
Flow rate exceeds high flow setpoint.
Flow rate falls below low flow setpoint.
Flow rate exceeds or falls below flow setpoints.
System loses receive signal.
Transducer spacing needs adjusting.
Empty pipe alarm.
Aeration percentage exceeds alarm setpoint.
Flow is in negative direction.
Batch/Sample total advances.
Positive total volume advances by 1 digit.
Negative total volume advances by 1 digit.
High Energy value relay setpoint.
Low Energy value relay setpoint.
Positive energy totalizer advances by 1 digit.
Negative energy totalizer advances by 1 digit.
Temperature difference relay setpoint.
Supply temperature relay setpoint.
High Chiller Efficiency value relay setpoint.
Low Chiller Efficiency value relay setpoint.
Fault condition - memory mode active.
ENT
2-64
1010ENFM-3B